How to use Bob


CONNECTION TO THE TAP


Bob connects directly to the faucet and it works only thanks to the water pressure, without the use of batteries or electricity.

 

To connect Bob just replace (only the first time) the filter holder of your faucet with one of the Bob special filters supplied, suitable for both male and female filter holders.

 

The special Bob aerator filter connects to all the taps with standard screwable aerator filter (standard CEN_EN 246). Once installed, it allows you to connect Bob in a few moments to tap allowing a normal use of the faucet and with the function of water filtration, aeration and water saving.

 

Bob can be connected to non-standard taps, using “Addy” the quick universal adapter (International Patent Pending). It is also ideal while travelling (included only in the “Travel” package or sold as an accessory).

 

You can connect Bob finally also the shower hose with the multifunction shower joint (accessory).


 

A)Connection with filter adapter for mounting to the tap.

You can watch the assembly steps in the video section

 



 

Connection with filter adapter for mounting to the tap.

Provided with BOB “basic” and “travel”

 

1) Unscrew the filter from your tap.

2)  Screw the provided Bob filter to the tap.

3) Connect the graft to the tap and use Bob.

 

 

 

 

   

 Connection with filter adapter for mounting to the tap.

 

 

 

 

Check to see if your faucet is compatible with our Water Powered adapters

 

 

 

B)  Connection with “Addy”quick universal adapter to the tap


Connection with “Addy”quick universal adapter to the tap

Included with the “Travel” kit or sold separately as an accessory.

1)    Place “Addy” the quick universal adapter on the tap without unscrewing it;

2)    Connect ”Addy” to the tap tightening the screws with the provided fastening key;

3)    Connect the gasket to “Addy” and use Bob.

 

 

 

  Connection with “Addy”quick universal adapter to the tap




 

 “Addy can be connected to all the taps with filter holder for the water flow with an outside diameter that varies from 16mm to 25mm with a minimum height of 5mm (All the standard taps have these parameters)."

 

 

 

  

How to use BOB

 

  1. 1.  Screw the rigid pipes to the handle
  2. 2. Connect Bob to the tap with the provided special filter holder or to "Addy" the universal adapter
  3. 3. Sit on the toilet, insert the nozzle in the anal duct and start washing.

 

In case you use the pipe, screw it to the nozzle, insert it in the anal duct and start washing.

 

 

How to use BOB


 
 
 
 --::--
 
 
For information on how to perform washing with Bob correctly visit the page FAQ in the section "How to perform a rectal lavage".
 
 

 

 --::--

 

 

 

adapters